We use several cookies on our site read about them here in our privacy policy.

RR-OL-PR2

The inked nylon is stuck, can't not run.

The inked nylon was stuck and reeled up by the gear wheels. Should open the cover of the cartridge and straighten out the inked nylon. 

The inked nylon can easily fluff,and becomes whitish.

A. Printer head was abraded seriously and became sharp. Should change the printer head.

B.The printer head is too close to the paper, which causes a heavy strike on the ribbon. Should adjust the distance between the printer head and the paper.


Light printing

A. Low ink content. Should increase the ink content.

B.The printer head is too close to the platen. Should adjust the distance between the printer head and the platen. 


Ribbon stop operating.

A.Wrong installment of the ribbon cartridge in the printer. Should instally correctly.

B.The printer drive shaft is abraded. Should change the printer drive shaft.

C. Wrong assembling when changing the tape; the nlyon is not straighten out. Should open the cartridge, correctly assemble the gear wheels and the flat spring, and straighten out the nylon.


After-Sales
Hotline
Email
contact@ggimage.com
Tel/Skype
+86 18666990417 (Dora)
Purchase